Coil Spring Spacer: - Front or Rear (rise approx. 1/2"
Originally designed by GM, these spring spacers are used to elevate vehicles as required. Suitable for standard coil springs from the 1950s to early 1970s, they measure approximately 9/16" (0.5625"). Especially useful if one side is down and you think a slight boost in one side height will help.
If somebody argues the point for rego etc.. the original GM number was 3789664.
These coil spring spacers provide a slight lift to one or both corners where coil springs are installed. Made from hard rubber, the open-ended coil seat features a stopper at the base, designed to fit securely at the bottom of the coil spring.
Manufacturer states the coil width.. 9/16" which is about 9 / 16 = 0.5625
Supplied in SINGLE UNITS .. you can use one or get more as needed. etc..
Couldn't load pickup availability
Originally designed by GM, these spring spacers are used to elevate vehicles as required. Suitable for standard coil springs from the 1950s to early 1970s, they measure approximately 9/16" (0.5625"). Especially useful if one side is down and you think a slight boost in one side height will help.
If somebody argues the point for rego etc.. the original GM number was 3789664.
These coil spring spacers provide a slight lift to one or both corners where coil springs are installed. Made from hard rubber, the open-ended coil seat features a stopper at the base, designed to fit securely at the bottom of the coil spring.
Manufacturer states the coil width.. 9/16" which is about 9 / 16 = 0.5625
Supplied in SINGLE UNITS .. you can use one or get more as needed. etc..
