This is the heater case as shown for the 66-67 GTO, LeMans, Chevelle, Malibu, Cutlass.. without factory AC.. And LH…
Heater control Valve for a variety of original fitment to late 60's early 70's GM Vehicles as listed.
CHEVROLET
CAMARO
(1969 -…
This is used inside many of the GM heater core housings.. retains the heater core into place.
Not known on…
Brand new US Heater core as shown... at this price they are not worth repairing .
This is for a NON…
This is the correct original fitment Heater core for 68-72 A bodies, .. ie GTO, LeMans, Chevelle, Cutlass etc..…
This is the Factory fitted heater core for various A bodies and the cars listed below.. that were made…
Simple set of 6 hose clamps from original style remake ... for factory Air Conditioned Cars.
Specifically for : *but used on others
Wide…
Simple set of 4 hose clamps from original style remake ... for NON AC Cars.
Specifically for : *but used on…
Heater / Manifold / Water pump hose outlet fitting.
Often seen as the outlet that takes the heater hose out of…
Heater / Manifold / Water pump hose outlet fitting.
Often seen as the outlet that takes the heater hose out of…
Hose support Pontiac W/o AC 65-77 V8.. goes where the AC compressor would normally otherwise fit. …
- Manufacturer
- Inline Tube
Set of original style tower hose clamps.
Good for a bit more restoration authentics when warranted.
This is a set of 8.…
This goes on the INSIDE of the car up on the firewall . helps limit the heat transfer into the…
This goes on the INSIDE of the car up on the firewall . helps limit the heat transfer into the…
- Manufacturer
- Repops USA
This pipe is in the rear TOP of the head on a "PONTIAC" V8 engine (not Olds or…
Simple job lot.. these two parts often rust out around the same time.. when made in tin.
…
This is a unique kit for Stainless Steel production parts JUST for Pontiac engines...for 69-81 Pontiac V8. All Stainless..…
Single belt AC pulley for the 68-72 era Pontiac GM vehicles.
mixed use.
7 3/8" x 3/8 offset (18mm)
center hole is…
67-79 PONTIAC 350,400,455 LOWER CRANK PULLEY - various PONTIAC applications
GM original part
Stamped code 481038YB - 8 inch or 20cm x…
- Manufacturer
- General Motors
Brand new stock of original early GM Receiver Dryers for the factory air conditioned cars.
Fits but not limited to:
…
This is the aftermarket receiver dryer for SOME ONLY 68-72 GM A body & full size vehicles... like…
Relay Fan blower Motor: 68-71 Firebird TA Camaro era and other vehicles as shown.
…
This is the Air conditioning relay for the Camaro & Firebird, 67 & 68.. and the GM A body cars…
- Manufacturer
- AC DELCO
This is a specific AC factory resistor located in the top of the heater box on the firewall.
Its outline is…
This is mounted on the engine bay firewall TOP of the heater box.
Image is correct.
There are a few different ones…
- Manufacturer
- OER
New heater blower resister located up under the dash in the heater box.
NOT FOR AIR CONDITIONED CARS.…
This is used on all Pontiac 1964-1979 factory Air conditioned cars
and 68-69 GTO hide-a-way headlight cars
and also all…
- Manufacturer
- Inline Tube
These Roller vents are located under the dash on various Pontiac 60's & 70's vehicles.. mainly those with factory AC…
Displaying 31 to 59 (of 59 products)