Five different sizes and strengths for the restoration needs on most US GM Vehicles will be met with this 50…
Securing Wiring under the edges of mudguards, dashboards, door shells.. inner body panels, chassis stretches etc etc cleanly is the purpose…
These are the oval door shell retainer plugs, found on Dash retainers and some rear side interior panels too... you…
This best described as Nail head pins attach to the door trim.
Pack of 26 provided.
Use with PW16269 Door Trim Plug…
50 piece vacuum/fuel hose spring clamp kit with these assorted sizes listed below.
Fits many needs on GM vehicles between 1960-1990.
Sizes Included:…
Usefull tool kit set for working most all clips and retainers on GM & Ford cars of the 50's…
This is the full glass clip kit for the 66-1980 GM various uses on big cars and…
Various GM applications for side moldings.
Is approx 3/4 inch long. or 21mm..
suits molds 1/2" (12.5mm) to about 5/8"
Supplied in 10…
From the OUTER front or rear of the UPPER CONTROL ARMS.. on most GM vehicles.. this bolt and what..…
When installing the fan shroud it will be necessary to…
- Manufacturer
- OER
Four clamps.. generally located on the front and rear of each fender skirt (or spats )
Set of 4 as shown.…
Brand new Rubber gearbox mount for the first gen Camaro & Firebird as listed below, fits a wide variety of year…
These micro round headed threaded grill repair or re assembly rivet will make a grille resto or fix up that…
Pack of 6 headlamp AF retaiing screws for a huge range of GM pre 81 (ie pre metric assembly move)
for…
These are the Headliner Clips used on (but not limited too) 68 - 72 GM Impala, Chevelle, Cutlass, Nova around the…
- Manufacturer
- General Motors
Used for over 50 years on various GM Vehicles.. this is ONE PAIR of heater hose brackets that fit on…
- Manufacturer
- OER
Usually 4 of these fitted 2 each side of the bonnet to limit…
Set kit of 8 loose washer headed bolts.
Kit of 4 each side.. not you may receive flat or pointed headed…
New Hood latch assembly as shown.. painted black as per factory.
Fits 1964 ONLY.. 1962 & 63 also…
Speciality correct repair for the those with Hurst Manual Shifter Lever.
Kit is as shown...RETAINER & INSULATOR KIT (4pce)…
This phillips headed heavy duty 1/4 x 5/8" screws retain the latch to the factory door frame and into the…
These clips hold the door lock knob rod in place. Broken or damaged clips will cause rattles…
- Manufacturer
- General Motors
Goes from the latch along the door shell inside to retain the long rod to the shell.. ie anti rattle.
…
Check the design of this gasket.. it fits many but not all original and aftermarket exterior door mounted chrome…
Use this to neatly retain the power steeing hoses together where needed.. Holds the hoses together.. not meant to be…
New precise nut and washer for the 64-77 era GM power steering pump to keep the pulley on.…
- Manufacturer
- Inline Tube
Pair thin radio nuts for the majority of factory radios in the 60 & 70's as shown…
These are widely used in 70- 2000's+ GM vehicle in trim retaining, shaft ends, heater control slides racks etc. Not…
Set of six specific rocker panel mounting clips for one side.... for the 64 Chevy Impala so fitted.
…
Fourteen part plastic clip kit as shown.. used mainly on 65-69 Impala side rocker panels
and many 62-64 Belairs.
…
Displaying 31 to 60 (of 90 products)