Just as shown.. the 1/4 upper center patch and forward panel.
Length is 17"/ 43cm x 45" / 114cm approx
Delivery is…
New Small underside stiffener between the new 1/4 panel & trunk /window extension.
LH is US Drivers Side.…
1967 & 68 Camaro & Firebirds are each different panels...very close to each but different.... they are…
Brand new tooling on these GM approved USA marketed Rear Coupe 1/4 panels just released May 2021. claiming better again…
There are two qualities of these currently being sold in Australia.. from two different pressings both done now in…
This shorter rear deck panel goes between the rear quarter panels, is used for repairing rusted deck area's…
- Manufacturer
- Reproduction
There is a couple of these now out on the market, this is the bit heavier one.. good sharp…
- Manufacturer
- Reproduction
This is the full CONVERTIBLE ONLY rear panel..
HINGED for the trunk lid.. includes mounts and tension…
- Manufacturer
- Reproduction
These "Y" braces support the rear of the back seat.. . .each car has two/ one pair.
Normally In stock.
Supplied…
This is a discounted kit of panels & supports as shown to repair the rear parcel shelf and inner support,…
The most complete rear deck panel for rebuilding the:
67-9 Camaro or Firebird Coupe or Convertible.
Comes with the main hinges.. deck…
At last.. a complete rear parcel shelf for 67-69 Camaro & Firebird that does not cost the earth.., rear support…
- Manufacturer
- Reproduction
This is a reproduction patch panel correctly stamped for replacing the shock mounts commonly rusted out rear shock mounting…
New Steel INNER rocker panels for the 67-9 F COUPE.
Choose the side you need.. all are as per factory fit...…
- Manufacturer
- Reproduction
Rust or damaged upper mount repair section for the 68-69 Camaro or Firebird.
Choose LHS.. US Drivers.. or RHS.. US Passenger.…
It is welded or fastened to the boot floor... oftern pulled out..? OER replacement part…
This is the genuine GM original hold down rod (only) comes with threaded length to to pipe thru the spare…
- Manufacturer
- General Motors
This original GM part is used to hold down the Inflation Cannister for your Camaro. …
A full set of 8 new screw in studs for the low profile REAR boot lid mounted spoiler used…
This kit comes with the rear spoiler fastener kit.
There has been at least 4 different qualities of these rear…
- Manufacturer
- OER
Jan 6th, 2024: THIS is a new rear spoiler damaged a bit on one end in transit or…
These are supplied without fitting…
- Manufacturer
- OER
This is the torsion spring UNDER the rear parcel shelf.
…
This is the torsion spring UNDER the rear parcel shelf.
This is the PAIR SET as shown.
This is specfic…
New USA made Detroit Speed branded weld in 1st gen subframe connectors as shown,
Supplied outright .. no return.
…
These weld-on subframe connectors from Hotchkis strengthen the chassis of your unibody to increase cornering and straight line performance.
They're engineered…
- Manufacturer
- Hotckis Suspension USA
If you want a cheap tail lamp panel.. grab one of these.... but otherwise don't. Supply conditions are you…
- Manufacturer
- Reproduction
This is the 1st Grade reproduction Tail Lamp Panel.
For 67-68 Camaro Std & SS..…
Displaying 31 to 60 (of 83 products)