GM 10 bolt rear with 7.5" & 8.2" ring gear..
Check style of inspection cover on diff center may look…
For most actual 10 bolt rear ends .. that have a 8.5" inch ring gear..
Double Lip Design
…
These parts are normally non wearing parts.. but needed due to loss or conversion from manual to Power Steering.
Pitman…
- Manufacturer
- General Motors
NUT & large spring washer for the pitman to manual or power steering boxes.
Fits LHD 67-72 Camaro Firebird as a…
Use this to neatly retain the power steeing hoses together where needed.. Holds the hoses together.. not meant to be…
Some power steering hoses are male or female ended.. going into a female power steering box.. per most GM Saginal…
New precise nut and washer for the 64-77 era GM power steering pump to keep the pulley on.…
- Manufacturer
- Inline Tube
Various requirement are net with this 5 & 3/4 inch (144mm) single grove pulley for the power steering on…
- Manufacturer
- OER
Hose as shown with the direct straight hose into the steering box.
This is for the full size cars..…
Single belt AC pulley for the 68-72 era Pontiac GM vehicles.
mixed use.
7 3/8" x 3/8 offset (18mm)
center hole is…
Repro of the 5.3/4" (148mm) deep groove power steering pump pulley used on various gm engines. May have #…
- Manufacturer
- OER
Correct rear axle bearing seal for the 1964-69 GM F body and A body. V8 & many 6's.
2 per car.
…
For the Manual transmission output shaft.. where the tail shaft YOKE goes into the rear of the manual gearbox.
…
This is a original service part kit for the Front UPPER Control Arm Shaft ....and bushes kit & hardware....…
This is the lower 60 cm (thats 2 foot for the old timers) speedo cable that unlike others has a…
This is a replacement speedo cable we special purchased by the hundreds.
It suits mixed applications & here we allow you…
- Manufacturer
- Reproduction
Neat speedo drive retainer kit for the Turbo Series GM Transmissions.
Kit as shown.…
These are for USA GM SINGLE PISTON.... Standard Height factory Disc brake .. GM USA factory disc…
- Manufacturer
- Reproduction
Correct strength replacement GM Type Steering Box BOLT & washer set:
Suites but not limited too:
63-74 era ++ GTO, Chevelle, El…
US Remanufactured GM original Power steering box for the various mid 60's to mid 70's (76 mainly see listing below)…
Steering Column BEARING RETAINER: 69-92 GM Various:
Suits:
Buick 69-76 most
Cadillac 76-77
Olds: 69-79 Cutlass various
Chev: 69-92 Camaro, 69-81 Chevelle & El…
This floating bearing presses into the lower tube of the steering column and the column tube runs through it.
For…
New standard use upgrade SOLID rear sway bar for the 64-72 GM A body cars as listed below.
Fits:
Pontiac GTO,LeMans, Tempest…
The Best on the market for a street car .. BUT.. read the manufacturers blurb too..especially about the changing…
Sway Bar KIT is SPECIAL ORDER.. allow 2 to 4 weeks
A front and rear set of…
This is just the bushings.. in USA made polyurethane.
Use LINK KITS if needing full…
- Manufacturer
- Energy Suspension
New Tie Rod End sleeves for most of the 1st gen F series in orignal form.
NOT…
Brand new OUTER tie rods as originally fitted to both Disc Brake & Drum Brake A bodies..
NOT for 71-72 or…
Inner Tie rod for the two years.. 71-72 A body.. All known engines.. all A bodies.
Fits: 71…
OUTER tie rod end for the 71-72 GM A body series..
Fits:
…
Displaying 61 to 90 (of 102 products)