ONE LOCATED DUE APRIL 2023 .. one only cost is about $ $275- $300
For 1978 (2nd half production) to…
- Manufacturer
- General Motors
To help with the constant requests for information on how to rebuild and proceedures involved and parts involved inside the…
Pin, spring and retainer for use with various 67-87 era all steering columns - inc 67-9 Firebird & Camaro (with…
Seal between the inner mounting plate and the firewall on the 69 Series F body…
There are two parts used from around 73 to 05, one with lettering on it with a grip collar..is on…
Wiring and spring assembled.. probably not hard to make but its available if needed.
SOME models used a shorter carbon spring…
JUST the SIDE CLIP shown in the main image box.. not the black switch - looks a…
Steering column mounted GM Neutral safety switch as shown... for the Automatic only.
…
This is the chrome pull knob on the hub of most all GM 67-70 steering colomns with hazard warning…
New Seal in behind the retainer plate on all 2nd gen F bodies as shown.…
- Manufacturer
- Repops USA
Up in the hub of the steering column whats left of this may be visible.. black or white .. as…
New Correct reproduction tilt lever for the majority of GM needs. from 68 to 88.…
JUST the SIDE CLIP or sometimes officially known as a contact switch.... often lost or…
This is the flexible boot that joins the upper knuckle to the shaft as shown.
Its a PITA to fit.
Size.
. across…
Original hazard warning light pull knob on the steering colomn.
May not be on all colomns.
used on 71-mid 80's normally
…
Cancelling cam as shown....light green colour ... for 69 & up GM WITHOUT tilt steering.
May fit other…
This is the joints in the knucle of the tilt steering column .. used mainly on 70 thru to…
- Manufacturer
- General Motors
This is the full set if needing to replace all the pull knob parts.. the 4 shown.
You may find you…
- Manufacturer
- OER
This is the early specific cancelling cam in the top of the steering column for the most GM Tilt columns…
Chrome and black knobbed turn lever for a swag of models that do not have cruise control AND are not…
New Horn Relay for the mid to late 70's GM vehicle as shown.
This is a three prong.
…
Best not to loose this if you pull the column down.. but now remade.
# 14 shown below.
This goes under the…
A replacement part.
NOT for 69-70 Firebird with NON tilt column.
Not to be confused with the ignition barrel and lock.
This part is 1/2…
Tool: Steering column PIVOT PIN Removing - 60-80's GM Columns.
This is one tool you need to get if pulling the…
Mounted on the interior of the car.. on the steering column housing.. close to the brake pedal arm.
Camaro /…
Suits a factory console shift tilt wheel AUTOMATIC '69 & to 92 cars with ignition on the steering column.
Not…
This is what's shown.. the upper steering shroud with side cover and gear / small parts.
Does NOT contain the bearing..…
- Manufacturer
- Reproduction
Various LHS cars may have this still in order for a MANUAL transmission.. this switch is at the…
This is as shown works on 69-95 GM steering columns.. tightening up the lower 25.4mm steering column shaft &…
Displaying 1 to 30 (of 35 products)