DISCONTINUED 1/06.. no more available. If needing something like this part.. common coat hanger wire is the same thickness..…
- Manufacturer
- General Motors
GONE 2020.. no more made. .GM discontinued.
Under the GM rear spoiler for all 1982-84 TAs and up to 1990…
- Manufacturer
- General Motors
THIS CLIP IS NOW DISCONTINUED.. we have NONE left.GM # was 14036396This small clip retains the hood/bonnet…
- Manufacturer
- General Motors
NO MORE DISCONTINUED
These small black clips attach to the side of the door assembly and hold the lock rods into…
- Manufacturer
- General Motors
White door trim clip that turns and retains with the backing board of the door trim sides and base…
These bring the transmisson lines together in a neat side by side line.
use as man as wanted..but normally maybe 3…
Each amber front side marker lamp (excluding Japanese Firebirds & Camaro with UGLY screw on lamps) is retained by…
- Manufacturer
- General Motors
The sqare threaded plastic nut that fastens the hatch interior side panels into place, 5 used all up, clips…
The tail lamps are retained by "finger grip" plastic housing spinner nuts.
Most Firebird TA's run about 6 on each lamp.…
- Manufacturer
- General Motors
Rubber strap with push though plug ends as shown. Used on the inner mudguards of most GM vehicles in the 60's…
This is the same special counter sunk screw that holds the cover for the TPI engine rear Dissy Cap shielf…
The plastic inner fender shield is retained mainly be push in plug screws.
About 8 are used per inner fender shield.
GM…
- Manufacturer
- General Motors
This is the often missing or unknown.. front and Center REAR of the bonnet / hood mounted Center adjustable…
These hold the plastic vent filler strip into the hood opening on the LH & RH rear sides of the…
- Manufacturer
- General Motors
These clips hold the door lock knob rod in place. Broken or damaged clips will cause rattles…
- Manufacturer
- General Motors
GM Manual Transmission speedo drive gear retaining clip.
One per car where used.…
- Manufacturer
- General Motors
Brand New part .. These are fitted to the very end of the front of the armest as it…
These are often missing or sprayed over.. but simply (and there may be other used in the car for this…
- Manufacturer
- General Motors
This is the GM Type wheel nut that has the plastic screw on cover screw onto it...
Original metric…
These big plastic screws locate retain the rear interior side panel into there captive nuts.
Choose Colour
Black
…
5 PACK ... Front and rear bumper skin and shield retainer or plastic rivet as they are also known......
Some cars…
This goes on the back of the pedal to keep it at the correct foot touch position.
Fits most all 1967-02…
- Manufacturer
- OER
Glove Box Door Bump Stops.
The correct pair of rubbers for the job.
Sold as a pair.
Used from late 1930's to early…
Small self threading screw with Torq head, approx 1inch long (25mil). Used in console face, door trim panel, some dash…
- Manufacturer
- General Motors
Securing Wiring under the edges of mudguards, dashboards, door shells.. inner body panels, chassis stretches etc etc cleanly is the purpose…
This is used on Auto Gear Knobs that have the round center depress designed knob. This clip slips UP…
This is the lower side mount batter clamp retainer for the 3rd generation.. 82-92 Firebird TA & Camaro &…
- Manufacturer
- General Motors
Used on seat trim to strap trim edges tight. .known as hog rings..
50 pack as shown.…
Rubber strap with push though plug ends as shown. Used on the inner mudguards fro 67-69 Firebird & Camaro &…
Displaying 1 to 30 (of 77 products)