SOLD.. no more.. and they were too cheap @A$ 204 +tax delivered.... but still took ages to sell... Check…
- Manufacturer
- General Motors
Used in various linkage applications for lock rods and opening rods on GM cars from about 1964.
Sold Each.
Fits LH or…
Used on the top outer sides of the rear bumper only.. specific clip.
Correct and Corvette ONLY .…
This rear side bump stop is found fitted to the bonnet, not the fender.. uses two per car.
(Consider a body…
Specific door lock clip for the later GM Vehicles.
The good thing about this clip .is the rod hole is…
5 PACK ... Front and rear bumper skin and shield retainer or plastic rivet as they are also known......
Some cars…
This is the lower side mount batter clamp retainer for the 3rd generation.. 82-92 Firebird TA & Camaro &…
- Manufacturer
- General Motors
Say what you feel..
"The Muscle Car Lives -
American Muscle - No…
Genuine part.. Door latch screw as shown.
Used on a WIDE range of GM vehicles. from the 1980's to early 90's.
Not…
- Manufacturer
- General Motors
12 pce mixed variety auto & General clip & Molding removal kit plastic panel separator that is not as damaging…
Used for over 50 years on various GM Vehicles.. this is ONE PAIR of heater hose brackets that fit on…
- Manufacturer
- OER
These are widely used in 70- 2000's+ GM vehicle in trim retaining, shaft ends, heater control slides racks etc. Not…
Up in the hub of the steering column whats left of this may be visible.. black or white .. as…
Windscreen Clip kit: Corvette.. 68-82 - C3 as shown.
Good simple correct kit.…
New Turn Signal lever with black knob as shown for the 67 Nova. Fits various 64-67 GM vehicles
…
Good Quality Corvette engine mount.
Supplied singularly.
…
This is the plastic pillar trim cover for the RHS (Aust. Drivers Side) seal trip trim.. as shown.…
Brand New Full Cable and Casing for the one year only 1984 Corvette. Does not cross fit to 1982…
Brand new pair of hood struts for the 84-88 Corvette
This is a PAIR.
You Get TWO.…
This is a USA made insert to allow you to rebuild your Corvette LH or RH engine mount..…
- Manufacturer
- Energy Suspension
Good tight used LHS Upper door hinge for the 84-92 series Corvette.
One only.…
Genuine Hood release handle for the Later 80s - 92 Vette series.…
Brand new GM Corvette rear hatch struts.
One each side needed. Supply as EACH... and do consider changing both or…
Repro of the 5.3/4" (148mm) deep groove power steering pump pulley used on various gm engines. May have #…
- Manufacturer
- OER
NEW GENUINE GM original exterior door handles for the 84-96 Corvette...
Available till these original GM handle stocks last. Discontinued GM…
- Manufacturer
- General Motors
Hinge Corvette FRONT end body '84-86 Scissor lift
Brand New part…
Brand NEW aftermarket GAS HOOD STRUT for the front…
Major Front End general bolt and fastener kit for the 60-80 era GM vehicles.
...around…
Displaying 1 to 30 (of 39 products)