Unfortunately now discontiued - No More as of Sept 2013
These were quite nice but…
This goes on the back of the pedal to keep it at the correct foot touch position.
Fits most all 1967-02…
- Manufacturer
- OER
Grommet and sleeve kit that installs where the accelerator rod fits into linkage.
…
Brake and cluch pedal thin specific shaft bushes as found on most all GM USA vehicles 65-81 era.
Set of 4.…
Ten peice screw kit for the kick panels on most GM vehicles from 66-72... as shown.…
There is a heavy plastic guard surrounds the steering column. These plugs…
Foot park brake & Clutch pedal pad for the manual transmission cars…
Foot park brake pedal pad specifically for the 64-78 era and then some.. .
Trim ring also available.
…
Correct reproduction of the accelerator alloy trim that fastens to the pedal pad. Suits a wide range of…
- Manufacturer
- OER
New Seal in behind the retainer plate on all 67-68 Firebird & Camaro., located.. on the steering column.. as its…
High quality general reproduction accelerator pedal PAD &
Trim bezel Set for those that simply want both.
Suits ALL 1968-81 A B…
Lower steering column seal inside the car.. will require the removal of the steering column to fit it properly unless…
- Manufacturer
- OER
67-69 Camaro & Firebird Floor Side vents.... these knobs and ferrules are used on the end of the vent closing…
1966-77 GM Manual Transmission Brake Pedal.. to Brake bracket swing arm mounting kit with bushes as shown.…
- Manufacturer
- Inline Tube
Pedal trim and Disc brake pad with the DISC BRAKE bezel as shown... as a 2 part…
This heavy plastic guard surrounds the base of the steering column under the pedals and secures the carpet from moving…
These are the current First Quality Sill plates.. we DO state what we supply per quality…
This is the grille on factory equiped kick panel speakers from the late 60's to around 69 on many GM…
This is the full manual pedal pad & trim kit for the manual gearbox..
1967-68 Camaro &…
- Manufacturer
- OER
1969- 71 era kit - Fresh six piece set for automatics …
60's authentic HURST white gear knob as shown.
Approx 45mm OD
It has the METAL inner threaded 3/8" …
This is the full pedal pad and trim kit for the Automatic series with DISC BRAKE…
- Manufacturer
- Reproduction
This is the full pedal pads and trim kit for the MANUAL vehicles listed below.
It contains both the Pad &…
- Manufacturer
- OER
Foot pedal support rods for the 67-68 Camaro or Firebird as shown.
Supplied in set of three.…
This does ONE seat.. fits a HUGE amount of seat bases where the platform allows flat surface mounting.
Order…
Excellent reproduction of the orignal accelerator pedal assembly, including arm pedal and bracket to the firewall.
This is an reproduction of…
- Manufacturer
- OER
This is the exact Firewall insulation pad, made the exactly as originally produced for Left Hand Drive vehicles..... these…
- Manufacturer
- Reproduction
Actuator and bracket for either side of the 1967-69 Camaro or Firebird.
Fits both LH (USA Drivers) or RHS as needed.
Comes as…
This is a 1969 only cable and lnk housing for Factory Camaro Firebirds AC systems.
It is both LH &…
Excellent reproduction of the 68-69 Camaro orignal accelerator pedal assembly, including arm pedal and bracket to the firewall.
This is an…
- Manufacturer
- OER
Displaying 1 to 30 (of 44 products)