Rusty or corroded trays are common after 30 odd years of use.. these are perfectly pressed and easy to fit.
Correct…
- Manufacturer
- OER
Type Two of this panel.. better suited for many rust fixing applications.
This is a factory replicated sectional pressing for the…
For the repair of the UPPER spring mount area of the subframe .. replacing worn out or rusted mount sections…
This panel usually rusts in any make of vehicle with time.
They join to the lower section of the…
- Manufacturer
- Reproduction
The ia a SINGLEunder trunk/boot floor re-inforcements were originally welded under the trunk floor to add support to the pressed…
- Manufacturer
- Reproduction
This is a run out of a of single skin front patch panel ..ONE ONLY..
USA Passenger Side only …
For 67-68 or 1969 Models.. Choose...
This is the OUTER REAR Wheelhouse from the center of the rear wheel…
- Manufacturer
- Reproduction
This is the lower front section of the rear 1/4 panel. Precision stamped panel ready for fitment.
Comes in any…
For the repair assistance on subframes where splits and wear deminishes the strength of the mounting support holes.
These…
This is a reproduction patch panel correctly stamped for replacing the shock mounts commonly rusted out rear shock mounting…
This is what the roof gutter mold clips onto.. this is the metal gutter..
It is the…
This Rear of Rear patch is designed for easy installation with original wheel well lip shape.
The metal correctly shaped …
- Manufacturer
- Reproduction
This shorter rear deck panel goes between the rear quarter panels, is used for repairing rusted deck area's…
- Manufacturer
- Reproduction
This is the 3 pieces used to repair the rusted weather seal channels.
Very useful kit and good value…
- Manufacturer
- Reproduction
These are under the front seat floor pans and form the structural reinforcement to mount the seats runners.
LH is USA…
These are under the front seat floor pans and form the structural reinforcment to mount the seats runners.
LH is USA…
This panel will replace the factory inner wheel well panels on your Camaro.
This is a superb quality restoration reproduction…
- Manufacturer
- Reproduction
The lower rear section of each front mudguard / fender is reproduced here enabling easier cut & replace restoration…
- Manufacturer
- Reproduction
This patch is designed for easy installation with original wheel well lip shape the patch is approximately 27 cms by…
- Manufacturer
- Reproduction
There are a few varieties of these.. not every "trunk floor" or boot floor is the same pressing or…
- Manufacturer
- Reproduction
This is a NEW retooled panel set that comes with the inner support brace section as well.
Made for the 67-8…
This patch is designed for easy installation with original wheel well lip shape the patch is approximately 27 cms by…
- Manufacturer
- Reproduction
These bulky new parts are available as either a left or right hand unit and are an excellent alternative to…
- Manufacturer
- Reproduction
This panel is the ideal replacement part if only your rear floor sections under where you put your feet...…
- Manufacturer
- Reproduction
The 1969 only in PAIR SETS of trunk/boot floor re-inforcements were originally welded under the trunk floor to add support…
- Manufacturer
- Reproduction
These are the front floor sections that run between the flat of the floor pan to the vertical flat of…
- Manufacturer
- Reproduction
This is the factory style pressing of the outer rocker panel for replacement use on either LH or RHS as…
- Manufacturer
- Reproduction
Type One of this panel.. has more going up the sides and the main guts of the floor needed.. with…
- Manufacturer
- Reproduction
Each 1967-69 panel extends from the rear seat section to the firewall extension upward near the transmission tunnel.
Each…
- Manufacturer
- Reproduction
Have a look at the 1969 ONLY panel... it is designed to fix rusty floor center area's s…
- Manufacturer
- Reproduction
Displaying 1 to 30 (of 38 products)