http://www.youtube.com/watch?v=ggRdEH-Wc4s
One of the better web access's on R&R 60- late 80's Ignition Locks in GM Cars.
Different years.. different methods.
Hope…
License plate Retainer nut for connecting the number plate to the bracket.
Supplied EACH (1)…
The correct gasket to seal your door locks to the door skin.. save then going metal to metal.…
This spring keeps pressure on the interior door opening handle. Used on most GM cars. up to around 1981 era.…
Specific door lock clip for the later GM Vehicles.
The good thing about this clip .is the rod hole is…
This goes on the back of the pedal to keep it at the correct foot touch position.
Fits most all 1967-02…
- Manufacturer
- OER
Pair of economy version chrome PLASTIC door pull knobs.
NOT METAL..
THESE HAVE THE DOMMED INWARD top.. NOT raised like post 67.
Used…
Goes from the latch along the door shell inside to retain the long rod to the shell.. ie anti rattle.
…
Pair of the softer thick gasket on the back of the inner door handles for the GM A body series.
Supplied…
Four hood hinge bolts.. 3/8 blunt end bolts as shown.
Widely used 50-70s GM vehicles.…
Ten peice screw kit for the kick panels on most GM vehicles from 66-72... as shown.…
Genuine part.. Door latch screw as shown.
Used on a WIDE range of GM vehicles. from the 1980's to early 90's.
Not…
- Manufacturer
- General Motors
A pair of screw & nut based .. rubber capped bonnet height adjusters & stops as shown.
Supplied as a pair…
- Manufacturer
- OER
For mainly GM door hinge spring... usefull specific us Door hinge Spring compressor as shown.…
The better type of door handle gaskets that have and edge to them.. not just a flat bit of…
- Manufacturer
- Metro Rubber
This attaches to the end…
These are the chrome handle with BLACK knob for standard interiors... .
This is currently also available in original GM at…
- Manufacturer
- Reproduction
This is the chrome threaded nut that goes around the various 66-67 Ignition locks on the dash mounted switch/lock combination.
This…
- Manufacturer
- OER
This is the windscreen clip kit for the 64-67 GTO/ LeMans & Chevelle/ Nova
24 clips.
If you…
These special square nuts are used to hold the license brackets and plate to the front valance panel and rear…
New Neat tailgate handle for the the 68 - 72 El Camino with washers as shown.…
Small parts kit for the fastening of the door trims to most GM Vehicles that used a metal press though…
This is the chrome handle used on many standard door pull opening trims... if this matches what your need.. ie…
Boot Lock Retainer: Chevy Chevelle 70-72 A body .. as shown.…
This is a replacement chrome finger/thumb turning ignition lock and key for the 69-early 78 Most all GM…
This are simply better door handle gaskets then commonly available. They are a little firmer but they are injected molded..…
- Manufacturer
- Metro Rubber
These Reproduction GM Approved Handles fit Standard Trim Cars and others: (Standard trim.. identified by your armrests are…
Chrome Interior Window handle with clip for the 64-67 Models.
Supplied EACH
Supplied for most GM Chevelle., El Camino, GTO,…
For the small handle vent cranking.. this is used on various mid - late sixties GM vehicles including the Chevy…
Displaying 1 to 30 (of 107 products)