Used with INSIDE retainer clip type yoke/Universal. for the Turbo 400 / TH400/4L80 Automative box.
Used with with factory uni joints…
Brand new drive shaft to Gearbox .. Turbo 350 Auto.. Yoke…
For the Harmonic Balancer needs of the Small Block Chevy.
One is one half.. = one engine needs.
You get two…
Brand new production Rally 1 rim for HQ stud pattern.. ie Chev…
- Manufacturer
- Reproduction
Plug the hold.. goes from 47 mm to 50mm range..simply push in the hole.. do not use greasers.. and tighen…
Helping when needed.. a single size welsh plug.
These are brass unless otherwise stated.
See size list attached.…
Full Chevy Small Block V8 factory type steel welsh plus and threaded gallery plugs as shown.
General fitting 1955- 1996 Chevy…
Full Chevy Small Block V8 mainly Brass type steel welsh plus and threaded gallery plugs as shown.
General fitting 1955- 1996…
New Professionally produced small block Chevy valve covers as shown, finished in Chevy Orange.
ONE set only.
3.5 inch or 90 mm…
Specific trans gasket with 13 bolt holes and one corner on 45 degrees.
IMAGE IS CORRECT.
…
These bring the transmisson lines together in a neat side by side line.
use as man as wanted..but normally maybe 3…
Transmission Filter KIT..for the alloy powerglide.
DO check your…
Chevrolet small block 1955-87. Dress up your engine for a customized look with these chrome plated covers.
Comes with gaskets and…
Suits the Small Block V8 Chevy.. 5lt (305)& 5.7 lt (350)
Felpro Kit as show.. huge application including:
…
New clutch throw out bearing for the GM V8 muncie gearbox line.
Found in later 60's & 70's GM
…
Small block 1955-79 standard Chevy sump.
Painted or unpainted.
Delivery covered when ordered & paid online for supply within Australia (addition…
Brand new reproduction sump for the following small block Chev years.
Image is correct.
FITS:
1970-79 Chevrolet Camaro V8…
Stock 1965-90 Big Block Chevy Oil Pan
V8 396 402 427 454 V8…
Sump plug for a wide range of GM V8's .. imperial thread.. 60's to 96 era.1/2"-20 thread …
This gear is needed when adding or servicing a Tremec manual transmission.
Fits wide range of Chev tremec applications.
Red gear as…
Neat speedo drive retainer kit for the Turbo Series GM Transmissions.
Kit as shown.…
This is a replacement speedo cable we special purchased by the hundreds.
It suits mixed applications & here we allow you…
- Manufacturer
- Reproduction
Speedo Cable.. this is the lower FOR CARS with Cruise control.. that have a split cable system.. this is noted…
This is approx 40/41 inch UPPER cable & casing.. only....normally used for cars with a cruise control transducer....
This cable goes…
Standard speedo cable for all the 69-77 GM cars and coupes .. without Cruise or cruise not wanted to be…
This cable SCREWS ONTO THE SPEEDO HEAD.. NOT clip on.
This is the standard Speedo cable and casing needed for the…
This is the lower 60 cm (thats 2 foot for the old timers) speedo cable that unlike others has a…
This easy to fit widely used OUTPUT Shaft extension housing seal for the transmission yoke sealing.. is available for worn…
FRONT SEAL on Powerglide, T350, T400 gear boxes for the GM range.
…
Displaying 1 to 30 (of 121 products)