http://www.youtube.com/watch?v=ggRdEH-Wc4s
One of the better web access's on R&R 60- late 80's Ignition Locks in GM Cars.
Different years.. different methods.
Hope…
Used in various linkage applications for lock rods and opening rods on GM cars from about 1964.
Sold Each.
Fits LH or…
The correct gasket to seal your door locks to the door skin.. save then going metal to metal.…
This is a correct GM style replacement part to hold your lock cylinder in place inside the door shell... slides…
These clips hold the door lock knob rod in place. Broken or damaged clips will cause rattles…
- Manufacturer
- General Motors
These GM service replacement knobs for the door pull open interior.. this is plastic chrome.
Fits a multitude…
- Manufacturer
- General Motors
Specific door lock clip for the later GM Vehicles.
The good thing about this clip .is the rod hole is…
This rod extends from the outer lock assembly to the inner lock assembly allowing the key to turn the inner…
This clip as pictured.. mounts to the door shell and retains the locking rods from rattling away or sag etc.
Supplied…
Small plastic retainer that holds the lock rods to the door shell on .. and not limited too.. 1969-81 Firebird…
This is the supply of ONE key or your choice.
Different years of GM production saw different designs of…
- Manufacturer
- General Motors
This is small bracket that attaches to the rear of the lock allowing the lock rod to be activated.
70-81 Firebird…
- Manufacturer
- Reproduction
This screws to the top of the inside of the dash housing and catches the doors lock button.
Supplied with two…
- Manufacturer
- OER
This is the chrome threaded nut that goes around the various 66-67 Ignition locks on the dash mounted switch/lock combination.
This…
- Manufacturer
- OER
This small kit may help restorers trying put the locking rods and handle interal rod linkages back together. It…
New production part just out.. used on all 67-69 Firebirds & Camaro's.. and certain other US GM cars of…
- Manufacturer
- Reproduction
Another quality OER reproduction part for the 1967 Firebird & Camaro. These lock knobs are supplied…
- Manufacturer
- OER
Generic Push button lock for the cars listed below.
Not meant to be a key lock . but a simple…
This is the backing chrome ignition indicator bezel that goes in behind the Ignition Switch Nut.
1967 Chevrolet Camaro
1967 Chevrolet Impala
1967 Chevrolet Bel…
- Manufacturer
- OER
This is a replacement chrome finger/thumb turning ignition lock and key for the 69-early 78 Most all GM…
Door lock internal linkage as shown...for the 69 ONLY Camaro and Firebird.. fits either door.…
This is the small plate that goes inside the glovebox opening for the 69 Firebird.…
- Manufacturer
- OER
This is a original style service part to replace those worn insulatored pins that end up simply making your doors…
This is the 6 tooth (SIX) gear at the end of the ignition switch for most all …
Each door... this is the rod linkage going from the doors LATCH MECHANISM to the door opening handle that you…
This 1966-67 Ignition lock comes with two new keys.
…
This ignition lock and key is a 1968 ONLY part.
Please do not…
Door lock and Keys kit:
67-68
Camaro
Firebird
Impala
Parisienne
67-68 Nova
…
Avoid destroying your bevel nut by using this factory bevel nut remover tool made specifically for the 1965…
- Manufacturer
- OER
Displaying 1 to 30 (of 51 products)