Bumper bolt, 1 inch regular US typical 60's - 70's chrome cap headed bolt as shown with the nut.
This is…
Stop the water getting in or fit the missing part with this cheap easy fix.…
These ROUND RUBBER plugs replace the damaged or missing plugs in your Camaro floor pan & boot area.
There is also…
Firebirds with a TRANS AM REAR :SPOILER as shown use this style of rear gasket for the boot lid.
Supplied in…
This is the double hock rod used on the 1st gen Camaro & Firebird as shown.…
These oval metal plugs replace the damaged or missing plugs in 50- 70's GM vehicles in cabin floor pan &…
This is the genuine GM original hold down rod (only) comes with threaded length to to pipe thru the spare…
- Manufacturer
- General Motors
New production part just out.. used on all 67-69 Firebirds & Camaro's.. and certain other US GM cars of…
- Manufacturer
- Reproduction
10 bumper bolts and nuts, each bolt is polished aluminum headed for excellent cosmetic match to the rear…
12 bumper bolts and nuts, each bolt is polished aluminum headed for excellent costmetic match to the rear bumper...…
Located inside on each side of the boot floor to 1/4 panel.. its where the return of the rear bumper…
New Production specific rear license bracket for the 68-72 era A & F body listed below.
with a 5.5 inch mounting…
These 67-69 Firebird or Camaro panels are often or have been often not been replaced in the past due to…
A full set of 8 new screw in studs for the low profile REAR boot lid mounted spoiler used…
When replacing the floor on the rear of any '67-9 Camaro & Firebird... these rear seat supports are needed normally…
This is the torsion spring UNDER the rear parcel shelf.
…
Type Two of this panel.. better suited for many rust fixing applications.
This is a factory replicated sectional pressing for the…
This is the outer bump stop that bolts to the body frame above the diff tubes on LH &…
- Manufacturer
- Reproduction
A new set of tension springs for the 67-9 Camaro & Firebird.If you have a spoiler on the…
This panel usually rusts in any make of vehicle with time.
They join to the lower section of the…
- Manufacturer
- Reproduction
Center support..down where the fuel tank neck comes up through the boot floor .. .. this brace supports the center…
The ia a SINGLEunder trunk/boot floor re-inforcements were originally welded under the trunk floor to add support to the pressed…
- Manufacturer
- Reproduction
This is inside the boot area .. goes from the boot / trunk floor to the opening for where the…
This outer side trunk floor panel is stamped as per GM original and is of the correct gauge steel.
USA…
For 67-68 or 1969 Models.. Choose...
This is the OUTER REAR Wheelhouse from the center of the rear wheel…
- Manufacturer
- Reproduction
This is the lower front section of the rear 1/4 panel. Precision stamped panel ready for fitment.
Comes in any…
SUPPLIED EACH . .IE ONE.. order two if for both sides.
This under floor rust repair panel located between…
This is the torsion spring UNDER the rear parcel shelf.
This is the PAIR SET as shown.
This is specfic…
This is a reproduction patch panel correctly stamped for replacing the shock mounts commonly rusted out rear shock mounting…
Displaying 1 to 30 (of 69 products)