This is a US product by "Supercool" AC System Flush.
Its listed to
Quickly penetrate and remove oil & contaminants from the…
This is a underdash AC System head.. not the engine side.
Click on the image to increase the size.
With so many…
AC clutch cycling switch for R12 gas type use.. if still using it but most cars had moved…
This is a simple reproduction of the genuine shaped and sized AC drain plug for most all GM…
This is the foam hood to aircleaner seals on the 69-71 Buick GS & GSX Small block.
Supplied as a pair.
These…
This mesh under the plentuim grill helps prevent leaves and other crap getting into the Fresh air vent system.
…
This mesh under the plentuim grill helps prevent leaves and other crap getting into the Fresh air vent system.
…
Cowl Vent Outlets: 68-72 A body Chevelle GTO ++ NON AC
..... in the kick panels..
This is Lh & RH…
This bit of plastic.. spears the air from the heater or air conditioning down to your feet level.
Not a cheap…
For the GM Chevelle, GTO, LeMans, Olds Cutlass, Buick's A body range..
this is the firewall seal kit for Factor AC…
64-72 GM A body heater box seal kit for factory NON AIR Conditioning cars as shown.
…
This is the BLACK metal box on the firewall for Small block & some big block GM original NON-Factory…
This is the BLACK metal box on the firewall for Small block & some big block GM…
This is used inside many of the GM heater core housings.. retains the heater core into place.
Not known on…
This is the correct original fitment Heater core for 68-72 A bodies, .. ie GTO, LeMans, Chevelle, Cutlass etc..…
This is the Factory fitted heater core for various A bodies and the cars listed below.. that were made…
Simple set of 6 hose clamps from original style remake ... for factory Air Conditioned Cars.
Specifically for : *but used on others
Wide…
Simple set of 4 hose clamps from original style remake ... for NON AC Cars.
Specifically for : *but used on…
Heater / Manifold / Water pump hose outlet fitting.
Often seen as the outlet that takes the heater hose out of…
Set of original style tower hose clamps.
Good for a bit more restoration authentics when warranted.
This is a set of 8.…
This is a specific AC factory resistor located in the top of the heater box on the firewall.
Its outline is…
This is an important little inline Filter used on various GM Applications in the AC system and often overlooked.…
- Manufacturer
- AC DELCO
This is one of the original pulleys used in heaps of 66-81 GM Vehicles pretty much across the range.…
- Manufacturer
- AC DELCO
Used for over 50 years on various GM Vehicles.. this is ONE PAIR of heater hose brackets that fit on…
- Manufacturer
- OER
This is mounted on the engine bay firewall TOP of the heater box.
Image is correct.
There are a few different ones…
- Manufacturer
- OER
Displaying 1 to 26 (of 26 products)