Inside handle kit with the CHROME knobs.
This 4 door set has the Chrome Dome in the Knobs.
for a 2 door coupe,…
2 door Inside handle kit with the black knobs.
The Difference between Belair and Impala is bugger all…
Inside handle kit with the black knobs & chrome dome knob center.
The Difference between Belair and Impala is…
61-64 Chev Impala / Parisienne 4dr P/L Door watershield Sets.. these go on before you put the door trims back…
- Manufacturer
- Repops USA
As shown this is ONLY THE CUT CENTER of boot floor. They are NOT Painted..
It has NO overhang ears/ sides…
This is the prestamped factory style rust repair panel under the rear seat of the 65-70 Full size cars…
Grommet and sleeve kit that installs where the accelerator rod fits into linkage.
…
Correct reproduction of the accelerator alloy trim that fastens to the pedal pad. Suits a wide range of…
- Manufacturer
- OER
High quality general reproduction accelerator pedal PAD &
Trim bezel Set for those that simply want both.
Suits ALL 1968-81 A B…
Pivot pin as found on the back of the accelerator pedal. The Spring also wraps around this.
High quality general reproduction…
- Manufacturer
- OER
This goes on the back of the pedal to keep it at the correct foot touch position.
Fits most all 1967-02…
- Manufacturer
- OER
Reproduction of the original armrest base molding installed on various 68 thru to 72 GM 12" armrest bases,..…
- Manufacturer
- OER
These are the set of 6 screws needed to attach the arm rest base to the door panels.
…
- Manufacturer
- Reproduction
New pair of armrest bases for:
62-67 IMPALA Rear (with ashtray)
62-64 Nova Chevy II coupe sedan & wagon.
62-67 Impala &…
- Manufacturer
- Reproduction
IF your needing just the plastic bases in a colour available .your come to the right place... Choose…
- Manufacturer
- Reproduction
Armrest pad for mainly 2 door cars.. 65-67 Chevy full size.
Length is approx 35 cm end to end. HOLE…
These quality reproduction arm rest pads ARE SUPPLIED IN PAIRS... each manufactured in modern materials for long life,…
- Manufacturer
- OER
New Chrome and black knob finished brand new reproduction blinker arm as shown.. for screw ON blinder levers.
Used in heaps…
- Manufacturer
- OER
1966-77 GM Automatic Transmission Brake Pedal bracket swing arm mounting kit with bushes as shown.…
- Manufacturer
- Inline Tube
1966-77 GM Manual Transmission Brake Pedal.. to Brake bracket swing arm mounting kit with bushes as shown.…
- Manufacturer
- Inline Tube
for the needs of rebuilding or replacement etc.. these seat assemblies come with the springs for base & Back as…
Brake and cluch pedal thin specific shaft bushes as found on most all GM USA vehicles 65-81 era.
Set of 4.…
This is as shown.. a new set of the housing and the screw on retainer for most 62-74 era…
Small parts kit for the fastening of the door trims to most GM Vehicles that used a metal press though…
Door trim METAL clips and cone round fastener pack of 24.
As shown.
fits various 1958-81 GM vehicles.
Suits:
…
Usefull tool kit set for working most all clips and retainers on GM & Ford cars of the 50's…
This is a Kit of 10 White door trim clip that turns and retains with the backing board of…
Nice real metal chrome plated coat hook for the early cars.. 55-68 era..
Pair as shown.…
Pair set of headliner mounted coat hooks.. with screws.
Available in Henry Fords favorite Colour.
These are found on mid 60's to…
This is the front latch handle for a heap of GM full size cars.
Nice Part.
Supplied in matched pairs.
…
Displaying 1 to 30 (of 136 products)