This is a NEW urethane moulded reproduction dashpad specifically for the Left Hand Drive 69 Camaro.This is fine for ordinary…
- Manufacturer
- OER
A quality reproduction of the factory assist / grab handle specifically for the 1969 Camaro..located above the glovebox lid.
Although made…
- Manufacturer
- OER
Sold as a pair only.
Normally for 1969 Camaro only.. but usable in various cars with grab handle strap # PW17923.
These…
- Manufacturer
- OER
This is the long black molding over the glovebox . .takes the CAMARO emblem and grab handles.
…
- Manufacturer
- OER
On the bottom run of the 69 Camaro dash is this SECTION if this is all that is needed..
In cherrywood…
On the RHS (of a LHD original location) lower run of the 69 Camaro dash is this SECTION if this…
The 1969 Camaro has a specific top panel for the dash and this is it...It is also used on the…
- Manufacturer
- Reproduction
This bit of plastic.. spears the air from the heater or air conditioning down to your feet level.
Not a cheap…
The full dash (Astro Ventilation) Seal kit to reseal or tighten up the dash sealing.…
- Manufacturer
- OER
This is the side 1969 Camaro Dash vent as shown.. its the twisting center section.. not the outer housing.
…
- Manufacturer
- OER
These are the LH or RH Sided outer dash vents for the 69 Camaro.. with the housing as shown.…
- Manufacturer
- OER
This is the 69 Camaro CENTER heater AC Outlet duct assembly for the AC cars as shown.…
- Manufacturer
- AC DELCO
The complete kit.. metal plates not vinyl stickon stuff.. the right trim plates..
This is designed to bring the dash…
These carriers have been hard to find for years and now thankfully are available new in an excellent reproduction.
It…
- Manufacturer
- OER
Newly available defooger switch bezel.
This bezel like all the reproductions we use is finished to a high quality of finish…
- Manufacturer
- Reproduction
67-69 Camaro & Firebird Floor Side vents.... these knobs and ferrules are used on the end of the vent closing…
This for the thick interior firewall pad..the wide bodied plastic lugs that help hold the pad in place.
Supplied in…
This is the exact Firewall insulation pad, made the exactly as originally produced for Left Hand Drive vehicles..... these…
- Manufacturer
- Reproduction
Brand New reproduction 1969 Camaro Glove box door as shown with hinge.…
This is as shown.. the glove box lid lock striker for the 1969 Camaro.…
This screws to the top of the inside of the dash housing and catches the doors lock button.
Supplied with two…
- Manufacturer
- OER
Simple Glove box LED bulb.. heaps brighter then the older filament style bulb.
Check the image.. as production pre 71…
Glove Box Door Bump Stops.
The correct pair of rubbers for the job.
Sold as a pair.
Used from late 1930's to early…
Seven of the specific self tapping screws with washers that secure the glovebox liner into place.…
- Manufacturer
- Reproduction
Heavy Cardboard glovebox liner for cars without OR WITH.. factory Air Con. - RIGHT HAND DRIVE conversions should pick WITHOUT…
Good simple look and connector as shown.. with the right colour for illumination orignal needs.
…
1969-70 Camaro Headlamp Knob and Shaft.
GM Restoration Part Approved exact.
…
- Manufacturer
- OER
For models with fold away headlamps... and only for ... this has the vaccumm outlets.
: 1968-77 Corvette with fold away…
- Manufacturer
- Reproduction
Inside the front edge of the head liner is this black plastic trim mould that holds the material in place…
- Manufacturer
- OER
When doing the major job of pulling out the heater system.. don't forget to go that one step further and…
- Manufacturer
- OER
Displaying 31 to 60 (of 104 products)