New chrome head screw for fastening the mirror mount bracket to the swival post coming from the actual mirror…
- Manufacturer
- OER
10 pack of chrome dome headed phillips slotted self tapping 50's- 70's screws.
#8 x 1 1/4"…
This is for both ends of the sunvisors.. the open rounded plastic bush goes into the chrome bracket helping…
- Manufacturer
- Reproduction
Brand New interior Light lens for 60's GM vehicles as shown.
Camaro: 67-69
Firebird: 67-69
Chevelle: 64-67
Nova: 62-69
This clips into the Chrome base…
- Manufacturer
- OER
Much brighter LED bulb for the INTERIOR replacement Bulb..Its twin pin as shown approx 40-42mm long baynet type shown.
Found on some license…
LED Interior bulbs just make sense.. much better illumination.. while lower heat..less lense destruction ongoing.
This is supplied as a pair..…
Chrome interior light lens base for various 60's GM vehicles.. where fitted with this design.
Camaro: 67-69
Firebird: 67-69
Chevelle: 64-69
Nova: 62-69
…
- Manufacturer
- OER
This is the center top black joiner for the 67-69 Camaro or Firebird Rear interior plastic molding.
One per car.
Comes with…
Pair set of headliner mounted coat hooks.. with screws.
Available in Henry Fords favorite Colour.
These are found on mid 60's to…
The sunvisor's on most 64- 72 era GM vehicles.. except convertibles.. the factory sunsisors pivot on one of…
- Manufacturer
- OER
These clips are supplied in sets of 4, and have been tough to get for yonks...
Not cheap…
- Manufacturer
- Reproduction
Simple trade style tool make tucking the head liner into the tight gap opening up the side particularly quite…
This is the set of Lens and Housing for the first gen Firebird & Camaro, early Chevelles and Nova's…
- Manufacturer
- OER
This is the interior lamp wiring that is tied into the headlining .. and punches into the interior lamp bezel…
Brand new rear parcel shelf speaker grill for the 60's GM Vehicles inc Camaro & Firebird.
Size is 6"…
Set of Clips for around the rear from rear side 1/4 to the other rear side 1/4 window, for the…
This is the boot or cover if you like that overs over the interior mirror bracket .. and the cover…
- Manufacturer
- OER
Located in the rear inner corner section where the headliner and seat shelf meet.
Supplied in Pairs... (may have individual…
- Manufacturer
- OER
Set of 12 special clips that hold the rear headliner mounting clips in place.
…
A Cheaper variety for 1967 ONLY.... but does not contain the pillar caps. For the covering edge when…
- Manufacturer
- Reproduction
This is the cardboard preformed rear of rear seat divider with the insulation padding attached.
Too big for post...delivery additional from…
This is the actual bracket that is attached to the roof header... the mirror is fitted to this bracket with…
- Manufacturer
- OER
Excellent brand new perfect reproduction Interior mirror with Day and Night flipper..... with Stainless steel backing.
This is the normal 10"…
- Manufacturer
- OER
Excellent brand new perfect reproduction Interior mirror with Day and Night flipper..... spotless Stainless steel backing.
…
- Manufacturer
- OER
A proper conversion kit for the round interior light design found in most Camaro and Firebird and many big cars..
Fits…
Inside the front edge of the head liner is this black plastic trim mould that holds the material in place…
- Manufacturer
- OER
These interior rear pillar mounted lamps were used on various 62-67 Chevy's including the 1967 Camaro. You'll find…
- Manufacturer
- OER
This is a raw uncovered set of the precut sail panels or "B Pillar" trim backing.. for the 67-9 Camaro…
Along the outside edge of EACH side the head liner is retained into place by this pinch weld grabbing headlining…
- Manufacturer
- OER
Interior headliner SIDE rear panels.. LH & RHS.. these come covered.. with the new stiffener behind it..ready to fit.
A number…
Displaying 1 to 30 (of 47 products)