A kit for restorers doing body work...of pre metric.. ie pre 81 back to the 50's.. restorers.. that will often…
- Manufacturer
- PWD
SINGLE RESTORATION NEEDS REPLACEMENT BALL STUD
for the accellerator pedal that used the Twin push on plug accelerator pad. Best to use…
This is good for restorers / owners of GM pre 81 or pre metric..
AF bolts and fasteners as show.
40 shims…
6 pce specific bolt kit for the 68-72 GM manual bell housing.…
Body mount bolt and washer kit as shown..
Covers 8 main bolt under body positions
and the 2 Radiator support mounts.…
This is the Energy Suspension body mount kit as shown.
Fits: 64-67 A body Convertibles:
ie.. GTO, LeMans, Cutlass, Skylark, Chevelle.
…
- Manufacturer
- Energy Suspension
This is a full body mount kit for the El Camino from 65-67 only..
If your…
- Manufacturer
- Energy Suspension
Ten position 14 Point kit as shown with the base hardware and sleeve for the 64-67 A body sedan and…
Body Mount Kit 68-72 A Sedan rubbers & sleeves (24Pce)
FOR THE 4 door sedan series.
Fits 68-72…
Special mounting colared washer for the body mounts on most all GM cars.
Two per pack.
2 2/5" or about 58mm dia.…
Bolts the engine mount to the frame .. the single each side HD bolts set.
This is a PAIR SET AS…
Four hood hinge bolts.. 3/8 blunt end bolts as shown.
Widely used 50-70s GM vehicles.…
This is a pack of 20 piece PACK of useful new GM style BLUNT END / FLAT END bolts and…
A simple handy body panel construction bolt kit.
This is a pack of 20 piece PACK of useful new GM…
As shown.. at least 6 different types of AF bolts used on fenders and sheet metal. fasteners for bracket retainers…
Found on SO SO MANY GM USA pre metric (aka around mid 80's) GM body construction.
Bolt has a pointed end…
Major Front End bolt and fastener kit for the 60-80 era GM vehicles.
...around 160 assorted fasteners and specific…
1968-72 Chevrolet Chevelle, El Camino, & Monte Carlo Front Sheet Metal Mounting Hardware, assorted for Fenders, rad support attachments, plugs…
Front end small parts & retainers bolt kit for the 68-72 Chevelle, Malibu & El Camino.
Helps to cover grill…
Stainless Steel V8 Big Block Chevy Kit for the 348 & 409 Chev
All bolts except fan and…
Factory exhaust manifold bolt and bolt/studs in a 6 pack as shown.…
Hex Head Stainless steel.. intake manifold bolt set as shown for the Small Block Chevy V8
3/8 x 1 1/4"…
This is the cable bracket for the LHD cars listed below. May or may not suit RH Drive conversions.
Suites:
70-72…
Clip Set - 10.
Full set of clips to suit all 68 & 69 Camaro coupe & convertible models with drum…
Round boot lid bump stop .. used on heaps of 60's vehiceles ... including but not limited too..
67-9 Camaro &…
Hood bump stops are used on most all GM vehicles. this one may be used as a pair or 4…
- Manufacturer
- OER
Full bump stop kit as shown with the bonnet front stoppers too.
Does the doors, boot, bonnet/ Hood sides, and glovebox…
Displaying 1 to 30 (of 105 products)