A full high quality replacement quarter panel for the 69 Firebird Coupe or Convertible.
WE WILL NOT SUPPLY…
- Manufacturer
- OER
This shorter rear deck panel goes between the rear quarter panels, is used for repairing rusted deck area's…
- Manufacturer
- Reproduction
There is a couple of these now out on the market, this is the bit heavier one.. good sharp…
- Manufacturer
- Reproduction
This is the full CONVERTIBLE ONLY rear panel..
HINGED for the trunk lid.. includes mounts and tension…
- Manufacturer
- Reproduction
These "Y" braces support the rear of the back seat.. . .each car has two/ one pair.
Normally In stock.
Supplied…
The most complete rear deck panel for rebuilding the:
67-9 Camaro or Firebird Coupe or Convertible.
Comes with the main hinges.. deck…
At last.. a complete rear parcel shelf for 67-69 Camaro & Firebird that does not cost the earth.., rear support…
- Manufacturer
- Reproduction
When replacing the floor on the rear of any '67-9 Camaro & Firebird... these rear seat supports are needed normally…
This is a reproduction patch panel correctly stamped for replacing the shock mounts commonly rusted out rear shock mounting…
Rust or damaged upper mount repair section for the 68-69 Camaro or Firebird.
Choose LHS.. US Drivers.. or RHS.. US Passenger.…
This is the genuine GM original hold down rod (only) comes with threaded length to to pipe thru the spare…
- Manufacturer
- General Motors
Firebirds with a TRANS AM REAR :SPOILER as shown use this style of rear gasket for the boot lid.
Supplied in…
A full set of 8 new screw in studs for the low profile REAR boot lid mounted spoiler used…
This kit comes with the rear spoiler fastener kit.
There has been at least 4 different qualities of these rear…
- Manufacturer
- OER
Those wanting a specific 1969 Firebird TRANS AM released one year one model rear spoiler this is it..
Made of Fibreglass,…
This is the torsion spring UNDER the rear parcel shelf.
…
This is the torsion spring UNDER the rear parcel shelf.
This is the PAIR SET as shown.
This is specfic…
A full 67-68 Firebird tail light panel..... years back we'd have to cut these out of cars.. like…
- Manufacturer
- Reproduction
Center support..down where the fuel tank neck comes up through the boot floor .. .. this brace supports the center…
This is a brand new tail light panel for the 69 Firebird.. long awaited reproduction.
Delivery via…
This outer side trunk floor panel is stamped as per GM original and is of the correct gauge steel.
USA…
Stop the water getting in or fit the missing part with this cheap easy fix.…
There are a few varieties of these.. not every "trunk floor" or boot floor is the same pressing or…
- Manufacturer
- Reproduction
Choose from either complete section 1967 or 68 models only panels... it is designed to fix rusty floors or damaged…
- Manufacturer
- Reproduction
This is a major time saving, perfect restoration part... a specialised ONE year only trunk floor for…
- Manufacturer
- Reproduction
Have a look at the 1969 ONLY panel... it is designed to fix rusty floor center area's s…
- Manufacturer
- Reproduction
Have a look at this complete section 1969 only TRUNK FLOOR PANEL... it is designed to be used for those…
Have a look at this complete section 1969 only panel... it is designed to fix rusty floors or damaged entire…
- Manufacturer
- Reproduction
This is the 3 pieces used to repair the rusted weather seal channels.
Very useful kit and good value…
- Manufacturer
- Reproduction
Displaying 31 to 60 (of 69 products)